Electronics Line iconnect Instrukcja Użytkownika Pobierz pdf (Strona 16)

3.8: Zone Bypassing/Unbypassing

The Penta offers the user the ability to bypass zones. When a zone is bypassed, it is

ignored by the system and will not generate an alarm when tripped.

To bypass a zone:

1. Press Q, 1.

2. Enter a valid user code; the System LED flashes and the LEDs of any currently

bypassed zones light up.

3. Enter the number of the zone to be bypassed; the corresponding zone LED lights up.

4. Press # to exit bypass mode; the bypassed zones flash.

To unbypass a zone:

1. Press Q, 1.

2. Enter a valid user code; the System LED flashes and the LEDs of any currently

bypassed zones light up.

3. Enter the number of the zone to be unbypassed; the corresponding zone LED turns off.

4. Press # to exit bypass mode.

Note: Disarming the system automatically unbypasses all bypassed zones.

3.9: Event Logs

The event logs record events that the system has undergone since the last arming. If

any events have been recorded in either event log, the System LED flashes until the

relevant event log has been viewed. In the event that a trouble condition still exists, the

System LED continues to flash until the condition has been remedied.

Emergency/Trouble Event Log

Zone tamper, keypad trouble or any of the three distress key alarms are registered in

the Emergency/Trouble event log.

To view the Emergency/Trouble event log:

1. Press Q, 2; the various trouble conditions are indicated by the zone LEDs.

The following is a summary of the trouble condition that each LED indicates when lit:

1 - Tamper or Keypad Trouble 2 - Alarm from P key

3 - Alarm from F key 4 - Alarm from E key

2. Press # to exit the event log.

Note: The event logs can only be viewed when the system is disarmed.

Zone Alarm Event Log

The Zone Alarm event log displays the zones from which an alarm was generated since

the system was last armed.

To view the Zone Alarm event log:

1. Press Q, 3; an alarm from a specific zone is indicated by the corresponding zone

LED.

2. Press # to exit the event log.

Both logs are automatically reset when the system is next armed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Brak uwag

Electronics Line iconnect Instrukcja Użytkownika Strona 16